Arrowhead Ceramic Conveyor Pulley Lagging
Corrects Belt Slippage And Premature Wear
Arrowhead ceramic pulley lagging provides the solution when conventional rubber lagging fails to correct belt slippage and wears prematurely. Our unique Arrowhead ceramic is designed for the highest drive factors unlike the conventional square tiles.
features and benefits
CORRECTS BELT SLIPPAGE AND PREMATURE WATER
MSHA approved for mine use – meets all requirements for flame-resistant solid products taken into mines. Acceptance Marking No. MSHA IC -174/2
Increase Productivity – by delivering increased traction between the conveyor belt and pulley, allows for lower belt tension than with rubber lagging.
Improved Conveyor Belt Tracking – due to the Arrowhead patterns self-cleaning ability, which reduces the material build-up and thereby eliminates the major source of conveyor belt misalignment.
Bonding Strength – that is superior to others, due to 3mm of our neoprene compound vulcanized into the bottom-side of the lagging.
Superior Wear – ability in abrasive or highly wet or dry applications as seen in below ground and above ground mining.
Easy Installation – can be done in place, on the plant site, at your local distributor or at the pulley manufacturer. Each strip is 10” (250mm) wide x pulley face (see chart).
Tile – fully enclosed by rubber with rounded corners to allow for better adhesion between the rubber and the tile.
Available – in 5/8”and 1” thicknesses in both SBR and MSHA grade rubber compounds.
INCREASE CONVEYOR DRIVE EFFICIENCY
Accurate Pre-Buffed Surfaces – for better wear and grip properties.
Precision Molded – only product providing diagonal grooves on ceramic tile lagging for self-cleaning.
Tile Design Features – high grade aluminum oxide ceramic tile fully enclosed by rubber.
Available – 5/8” and 1” thicknesses in both SBR and MSHA grade rubber compounds
Arrowhead™ NAT Ceramic Drive
BELT WIDTH IN.
BELT WIDTH MM.